You are currently browsing the Collector Model blog archives for the day Tuesday, May 21st, 2013.

Recommended Sites

Calendar

May 2013
M T W T F S S
 12345
6789101112
13141516171819
20212223242526
2728293031  

Archive for May 21st, 2013

The 4-H Project: Cleaning the model

posted by RJ 10:18 AM
Tuesday, May 21, 2013

 

Our first step was to clean all of the parts. Since we learned from our 2012 experience, we knew that for the paint to stick evenly all parts had to be clean. Dust and oil inhibit the adhesion of paints and glues, as well as detract from the final appearance of the model.

Soapy-Water

To remove dust and oil, we simply washed the pieces (still on the sprue) with warm water and a very small amount of detergent. We used the sink, however you may also wish to use a shallow basin and a strainer to ensure that you do not lose any small pieces down the drain. We let them soak for several minutes, agitating them occasionally. Taking the pieces out, you can leave them in the strainer to rinse thoroughly, the lay them out on paper towels and dry them thoroughly with a clean paper towel.

Some modelers suggest removing pieces and assembling prior to painting, however out 4-H leader suggests that is all items on a sprue will be the same color, you can paint them while still attached.

Small scissors or shears can be used to remove the parts from their respective sprues. Using a knife to remove parts is difficult, dangerous, and may damage the part. Only when the part is removed may you use a fine knife to remove any flash or excess sprue still attached, this is where we use the small nailĀ  clippers they are easy for him to handle alone and less dangerous than the sharp small knife.

css.php